The TorkLift PowerArmor Solar Locking Battery Box part # TLA7700LS is not wide enough to fit two group 31 batteries. Group 31 batteries are 13" long by 6.72" wide by 9.44" tall.
The only option that's big enough is the Commercial Grade Battery Box # 329-HM485. This is designed for dual 8D batteries which are a bit bigger, but it will work well with your two group 31 batteries.
If you're set on a solar powered battery box, the only other option is to use a TorkLift PowerArmor battery box,... view full answer...
The Commercial Grade Battery Box # 329-HM485 you found is going to be our only vented battery box which is capable of housing your 2 Group 29 batteries. The internal dimensions for this box are 23" wide, 21" long and 10-5/8" tall.
If this is too large of a box you can use separate Battery Boxes # 329-HM318BKS to hold each battery individually. view full answer...
For venting a battery box to the outside of an RV we have the vents for the side of the RV with the Valterra Battery Box Cone Vent # A10-3300-05. That said we don't have a totally sealed battery box that will fit both of your batteries. We have boxes that could fit both of your batteries but the lids of them are vented so it would not be ideal for your batteries unless you were able to create a sealed room for the battery box. It looks like most people make custom enclosures for the batteries... view full answer...
The inner dimensions of the Commercial Grade Battery Box for Group 4D Batteries # 329-HM408 are 21-3/16" long x 9-5/8" wide x 11-1/8" tall. Based on the dimensions of your LifePo4 batteries you'd easily be able to fit two in this box. view full answer...
We offer lots of choices in camper battery boxes that you can see by clicking on the linked page. These range from value-priced single-battery plastic boxes to sturdy multi-battery locking boxes like the TorkLift PowerArmor Locking Battery Box # TLA7710R and to the similar model # TLA7710RS that includes a solar panel to provide a maintenance charge to the batteries.
Your best option will depend on the available space on the pop-up to install the boxes. view full answer...
For a battery box it is going to depend on the dimensions of your group 27, 12-volt batteries. Based on some of the batteries I looked up we have a couple of boxes you could use. First is TorkLift PowerArmor Locking Battery Box # TLA7708R. Attractive, strong, and durable, this is the last battery box you would need.
The dimensions of this box are 26-3/4" long x 8-3/16" wide x 13" tall. view full answer...
Per manufacturer the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box, # TLA7726 is approximately 8.5" center-to-center across and 3.5" center-to-center vertically. The battery box does have vents and allow cables to pass through for connection to terminals. The battery box is held in the tray with a strap. This is designed to fit the 2010 - 2014 Ford F-150 SuperCab or SuperCrew with a 6-1/2 Foot Bed view full answer...
The TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box # TLA7730 or the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box # TLA7726 are ideal for the mount style and location you need. If you want a metal box, then I recommend the Tow-Rax Battery Box - Polished Aluminum - 12" Long x 8-5/8" Wide x 10-7/16" Tall # TWSP12BP.
If you want to use a box like the TorkLift PowerArmor Locking Battery Box - 6V and 12V Batteries - Diamond Plate Aluminum # TLA7708R then... view full answer...
The TorkLift PowerArmor Locking Battery Box - 6V and 12V Batteries # TLA7708R would be a great choice and can fit up to two group 31 deep cycle marine batteries. This battery box would be mounted anywhere on the trailer that has steel or aluminum, however that would require some fabrication. You would have to make some type of mounting bracket for the battery box and weld it onto the trailer.
Or you can use something like the Tow-Rax Battery Box - Polished Aluminum # TWSP14BP in which... view full answer...
The TorkLift PowerArmor Locking Battery Box for 6V and 12V Lithium Batteries #TLA7700L is designed for Lithium batteries. Lithium batteries are typically taller and more narrow so this battery box is designed to better support that size.
The box features two sections inside the box to hold two batteries and each area measures 13-3/8 inches x 7-1/4 inches with a height/depth of 10 inches.
I looked up the Battle Born Lithium batteries and the largest size battery was 12-3/4 inches x 6-7/8... view full answer...
I spoke to my contact at TorkLift about the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box part # TLA7740 and they informed me that you would not be able to mount two 6 volt batteries side by side in the box due to the limited length. Unfortunately, the bracket is not sold separately from the box.
I have attached a photo with the internal dimensions of the above battery box for you but for an option that will allow you to mount two 6 volt batteries side by side, I recommend... view full answer...
We have numerous battery boxes, see link below, some are smaller than the battery size you have and some are larger. The box you end up with will most likely have at least one physical dimension that is much larger than the same dimension on the battery.
For example the Tow-Rax battery box # TWSP12BP is 12 inches long, 8-5/8 inches wide, and 10-7/16 inches tall. Plenty of space for the battery and any wiring going to/from it.
A plastic box such as # DW03188 is a good option as well. It... view full answer...
I went out to the warehouse and pulled the Vented Battery Box, # DW03188, and produced a short video showing the dimensions of the box for you, see link.
The inside dimensions of the box with the lid removed are 8-1/4 inches long, by 5-1/4 inches wide at the bottom of the inside of the box, and 6-1/8 inches deep.
The overall outer dimensions of the battery box are 10-1/2 inches long, by 7-3/8 inches wide, by 9-1/4 inches high, with the lid on the box.
You may also be interested in the... view full answer...
I went out to the warehouse and pulled the Vented Battery Box, # DW03009, and produced a short video showing the dimensions of the box for you, see link.
The inside dimensions of the box with the lid removed are 10-3/4 inches long, by 7 inches wide at the bottom of the inside of the box, and 8-1/4 inches deep.
The overall outer dimensions of the battery box are 14-1/4 inches long, by 9-3/4 inches wide, by 10-3/8 inches high, with the lid on the box.
You may also be interested in the... view full answer...
It sounds like you are looking for a trailer battery box that mounts at the front of the trailer near the tongue and coupler (the coupler is what grips the hitch ball on the tow vehicle).
Battery boxes usually have some sort of ventilation, such as on the Tow-Rax Battery Box # TWSP12B which uses a clear plastic tube for this function.
You'll want to check the battery type number for your two batteries since many of these boxes fit only specific battery sizes. I linked our main page... view full answer...
Battery boxes are universal items since batteries vary in size so when looking at them you need to make sure your battery will fit.
The original battery box we had for 6 volt golf cart batteries only had a internal dimension of 9-1/4 inches so it would not fit your battery, like you said. The current box we have is the NOCO, part # 329-HM306BKS, which is taller measuring 10-5/8 inches long, 7-5/8 inches wide, and 11-3/16 inches deep.
As long as it's still long enough this battery box... view full answer...
We do not have a battery box with a metal frame to fit batteries of those dimensions. The only thing we have close is the Battery Box Vented - U1 # DW03188, but it is a plastic box. view full answer...
I recommend the NOCO Commercial Grade battery box part # 329-HM484 to hold both of the group 24 batteries. From my research a group 24- 12 volt battery measures 10.25" long x 6.8125" wide x 8.875" tall. This battery box measures 21" long x 11-13/16" wide x 10-5/16" tall of internal usable space. This is the most cost effective box that we carry that is spacious enough for the 2 batteries. I would measure the regulator and make sure it can fit with the two batteries though. I have attached... view full answer...
We do have a battery box though the Curt battery box you referenced does not have the correct length for your battery, which is just over 5-3/4" long. Instead, you will need the Replacement Clamp-On Battery Box for Tekonsha Trailer Breakaway Kit # TK2018 because it measures 5-15/16" long x 5-1/16" tall x 3-3/8" wide.
I have added a link to a video review of this battery box for you to check out as well. view full answer...
According to my research, Group 27 batteries measure 12" long x 7" wide x 9" tall so to hold 3 Group 27 batteries I recommend using the TorkLift PowerArmor Locking Battery Box which comes as a plain box with part # TLA7710R or a box with a small trickle-charge solar panel as part # TLA7710RS.
This box measures 58-1/2" long x 7-5/8" wide x 12-3/4" tall so it can actually accommodate up to 4 Group 27 batteries which just means you'll have extra room for any tie-downs or other equipment as... view full answer...
Go To Results